First, the installation method of ZW attached concrete vibrator:
1. Generally divided into two types: moving surface vibration and fixed-mounted component vibration. When used as a surface vibration, install a wooden board (or iron plate) at the bottom of the vibrator and fix the vibrator to the bottom plate for use.
2. When used as a fixed component vibration or when installed in other vibrating machines, the method of installation should be determined according to the design requirements.
3. When the vibrator is installed, the mounting screw holes of the bottom plate should be correctly positioned. If the hole position is not correct, the vibrator installation will be difficult, or the mounting screws will be seriously skewed, and the casing will be subjected to abnormal stress, which will affect the use. life.
4. The nuts of the bottom plate mounting screws must be tightened to prevent looseness, but the force should not be too strong when tightening, so as not to damage the housing feet, and the four mounting screws are required to have the same level of robustness.
Second, the operation of ZW attached concrete vibrator:
1. It can be used as long as the 415V power supply is turned on.
2. When the vibrator is in trial operation, it should not be used for long-term dry operation on dry and hard soil, because this will cause the vibrator to vibrate and cause damage.
3. When the vibrator is moving, keep the four-core wire of the motor to a certain length and deflection. Do not over-tighten the wire to avoid the wire breakage.
4. When installing and operating the vibrator, always pay attention to the electrical safety measures. The safety circuit should be installed in the power line.
5. If several vibrators are installed in one component for work, the performance may differ from that of a single vibrator. At this time, the frequencies of the vibrators must be consistent, otherwise mutual interference may occur.
6. For more complicated installation and operation problems, it should be properly handled in the design.