First, the use of field machine 1, the operation, the field should first be raised to the hammer claw from the ground 20 to 25 cm high (lifting position can not be too high, so as to avoid excessive damage caused by joint deduction) joint power output Shaft, turn for 1 to 2 minutes, hang up the work gear, slowly release the clutch pedal (if you use Tieniu -55 when you need to use a second-level clutch), and operate the hydraulic lift adjustment handle, gradually reduce the returning machine to the required Keep the height of the raft, then increase the throttle, and put it into normal operation. 2. When working, do not allow the hammer claws to hit the soil to prevent infinite torque increase and cause malfunction. If you find that the hammer claw hits the soil, you should adjust the height of the ground or the length of the suspension rod on the tractor. 3. The turning machine should be raised when turning, and the work can be done after turning. When the field machine is raised, it is necessary to pay attention to stability when landing, prohibit backwards in the work, and cut off the tractor to output power when transporting on the road. 4, the operation should pay attention to clear the wrapped grass, avoid obstacles such as soil, tree stumps, land to stay 3-5 meters of the unit turning zone. 5, if you hear abnormal noise during the operation, you should immediately stop the inspection, and then continue the operation after troubleshooting. 6. The degree of tightness of the belt should be inspected at any time during the operation so as not to reduce the rotation speed of the cutter shaft and affect the crushing quality and increase belt wear. Second, the safe operation and precautions 1, the operator must first be familiar with the performance of the machine, according to the operating instructions operating equipment. 2. The gearbox oil should be filled with 30# gear oil before use. The height of oil surface should be immersed into the oil surface by one third. 3, universal joint installation should pay attention to the following three points: A, should ensure that the machine tool in the work of promotion, the square shaft and the sleeve and the ends of the cross are not top dead, but also have enough length. B, universal joint assembly position and direction should be correct, if the wrong direction, will produce noise and strong vibration, and increase the damage to the joint. C. When supporting with 55 and 60 hens of Tien Niu, the fixed support rods of the cylinders shall be changed to flat irons so as to avoid mutual collision when the universal joints rotate. 4. Shimoda operation is strictly prohibited when the lyricism is too large.
Frozen Fish,Frozen Bonito Tuna,Frozen Mackerel Fish,Fresh Frozen Mackerel Fish
ZHEJIANG RETRONX FOODSTUFF INDUSTRY CO.,LTD , https://www.retronxfoods.com