Glass mosaic tablet press

The glass mosaic tablet press is a rotary tablet press developed by the company zui. It is specially used to make glass powder raw materials into mosaics of various shapes and sizes. As the market demand continues to change, the glass mosaic tablet press can not only suppress small mosaics, but also suppress large mosaic products, such as: 12*12mm, 15*15mm, 20*20mm, 23*23mm, 25*25mm, etc. The size can be pressed, just replace the mold. In the production process, the automatic block machine produced by our company can realize the automatic operation, and the pressed tablets can be directly pushed to the sintered plate through the block machine, which greatly improves the production efficiency. At the same time, the noise is small, the pressure is high, and the overpressure is stopped to avoid damage to the machine.

First, use

1. The quality of the die must be checked repeatedly before use. Whether there are missing edges, cracks, deformation and looseness requirements, and whether the device is intact or not.

2, Check whether the powder of the granular material is dry and the powder content of the granules is not more than 10%. If it is unqualified, do not use it hard, otherwise it will affect the normal operation and service life of the machine and the loss of raw materials.

3. For the first test run, place the indicator of the pressure adjustment control at the “0” position, pour the powder into the bucket, turn the test wheel by hand, adjust the filling and pressure, and gradually increase the weight and hardness of the tablet. To the extent that the finished product is required, the motor is first turned on, and then the clutch is opened to perform the official operation. During the production process, the quality of the tablet must be checked regularly to meet the requirements and adjusted if necessary.

4, the choice of speed has a direct impact on the life of the machine, due to the nature of the raw material viscosity and diameter and pressure can not be uniformly defined in the use, The structure is divided into two types: fast and slow. The slow speed uses the long triangle to drive the outer sheave. It is suitable for pressing minerals, plant grasses and other materials that are difficult to form quickly, and quickly drives the inner sheave with a short triangle. It is suitable for pressing adhesive, lubricious and easy to shape materials, so the user must be determined according to the actual situation.

5, the manager must be familiar with the technical performance of the machine, internal structure, the use of control mechanisms and do not leave the work site during operation, to prevent damage to the machine and to ensure safe production.

6, in the use should always pay attention to whether the machine sound is normal, in case of a scream called stop to check and eliminate, not

Second, the machine parts lubrication

1. The general parts of the machine are lubricated, and the outer parts of the parts are equipped with oil cups and oil nozzles. According to the type of oil cup, please note the butter and the oil separately. Before driving, you should add all the oil once. You can add it according to the temperature rise and operation of each bearing.

2. The glass oil cup in the middle of the upper cover is the bearing of the lubrication turntable, which is 3-5 drops per minute during transportation.

3. Rolling bearings are installed at both ends of the drive shaft. The shaft housing is equipped with an oil nozzle. It can be refueled once a week and pressed with a grease gun.

4, the tail of the punch and the curved rail guide with grease lubrication, pay attention to not too much, to prevent oil from seeping into the powder and affect the quality of the tablet.

5, When refueling, care should be taken not to let the oil seep out of the cup, and not to flow around the machine and on the ground, because oil can easily cause material contamination to affect the quality of the tablet.