The production task of the breeder farm is to provide the hatchery with the highest quality eggs in order to provide the user with high quality chicks, and the egg box as an important part of the production of qualified eggs requires effective management.
Physiologically, breeders have the habit of finding clean, dry, dark, and secluded environments. Laying hens also like to produce in sheltered areas, because it takes about 15 to 30 minutes for hens to lay eggs, and to avoid stress when the fallopian tubes fall out. The body temperature of chickens often rises by 2°C~3°C during laying, and requires the nests to be well-ventilated but without the wind, so the side plates and partitions of many egg boxes are made into fences or holes. The design of the nest box should be able to meet the natural habit of laying hens, which is also the basic requirement for designing the nest box. Nesting boxes can be made of various materials such as bamboo, wood, and tin, but no matter which kind of nest boxes are used, the number of eggs is generally 4 to 5 chickens and one egg nest. Hens also have a habit of fixing egg production sites, and hens like to lay eggs on the first egg. The lack of quantity will increase ground eggs. Egg boxes are generally designed to be 1 to 2 layers. The size of each egg socket is about 30cm wide, 35cm deep and 30cm high. The bottom pedal of the carton should consider the use of an active pedal. The height of the leading edge baffle must be sufficient to maintain enough litter in the nest. The following are some specific plans for managing the nest box:
1. The hen must have enough time for the nest box to adapt. The preparation work must be completed before the start of production. The compartments of the batch housing should be installed before the hens are transferred in. Generally, the hens will be better housed after 18 weeks. The full house is generally 22 weeks. Place the nest box to take into account the distribution of the light source in the house, so as to make the box dark and keep the light intensity under the box. No light line is required above the nest box. The egg cartons should be placed at right angles to the side walls. They should be opposite to each other, that is, each side of the egg cartons should be on opposite sides. One end should sit on the scaffold at about 30 cm, and the other end should be hung on the roof or supported on the ground by an iron frame.
2. The initial nest box can be placed on the ground first, and then gradually raised. The height of the box is suitable for the hen to enter and exit without being contaminated by the litter on the ground. At the same time, the hen is provided with a place to avoid the cock harassment. The usual height is 30 to 45 centimeters, generally the bottom of the box The distance between the pedal and the padding shall not exceed 45 cm, and the interval between the bottom pedal and the second floor shall not be less than 15 cm. In order to prevent chickens from nesting under the egg box and avoid copulation, the feasible method is to isolate the space below with a partition net. This will undoubtedly reduce the living space of the chicken. Some manufacturers' measures are to further improve the nest box. At a height of 60 cm from the ground, this height allows more light to enter, plus the cock can also get under the nest box, and here it is not a good place to nest. However, some people think that this height will only be difficult to go up.
3. Normally hens will rely on nature to find safer places to lay eggs, so management should minimize the types of alternative safe places (except nests), such as the use of feed lines and the distance between feed lines and side walls. Less than 30 centimeters, this narrow area will become the gathering place of the ground eggs, the same place there is under the bucket, so the use of the barrel of the chicken house must be suspended after feeding, some manufacturers of cockerel bucket is fixed, Therefore, it should be noted that the general way to prevent such trends is that all of these areas have sufficiently uniform light intensity from different angles.
Gasoline-Vacuum Pump Dual-Typed Milking Machine is made with both Gasoline motor and Vacuum Pump motor, so it works with either motor is ok.
This type machine is more convenient based on its double function.
Gasoline-Vacuum Pump Dual-Typed Milking Machine is usually fitted with two buckets, so the efficiency for worker`s milking is higher than one bucket only. For small farms far from the city, double function can handle with some emergency situation such as gasoline shortage or power cut.
Gasoline-Vacuum Pump Dual-Typed Milking Machine can be also customized with four cup groups, and can be designed based on customer`s request.
Gasoline-Vacuum Pump Milking Machine
Gasoline-Vacuum Pump Milking Machine,Dual-Typed Milking Machine,Vacuum Degree Milking Machine,Gasoline Buckets Milking Machine
Zibo Maoyang Industry and Trading Co.,ltd , http://www.mysilage.com