When a farm vehicle is driving, it is inevitable that tires will be deflated, nailed or punctured. How to replace the spare tire as soon as possible? The methods described below will allow you to change tires quickly and well. 1. Keep in mind the direction of rotation of the wheel fastening bolts. The nut on the right side wheel is made into right-hand thread (orthodontic), and the nut on the left side wheel is made into left-hand thread (reverse teeth). Therefore, when loosening the left wheel nut, it should be forced clockwise. When tightening, it should be counterclockwise. 2. Twist the nut diagonally, crosswise, in 3 or 4 turns to prevent the disc from being deformed and the force concentrated on the individual wheel bolts. 3. When disassembling, first use a socket wrench to loosen the wheel nut and temporarily remove it. Then use the jack to lift the axle, until the tire slightly leaves the ground, then loosen the nut and lift the wheel. 4. Apply lithium-based or calcium-based grease to the thread first to reduce the possibility of sliding. When lifting and lifting the wheel, align the bolt holes so as not to damage the bolt threads. When tightening the nut, tighten it by hand, then loosen the jack under the wheel with a special wrench. When the jack is released, lift the jack and let the wheel fall to the ground. Use a torque of 200-400 Nm to cross-tighten each wheel nut. 5. When installing the tire assembly, the valve of the tire should be aligned with the inclined surface of the brake drum. 6. For the rear tires equipped with twins, the following points should be noted: 1 If the wear of the two tires is not the same, one with a larger diameter and a lighter wear should be installed on the outside to accommodate the arched road. need. 2 If only the outer tire is replaced, tighten the inner nuts of the inner wheel first and then the outer wheels. When the two tires are replaced at the same time, jacks should be lifted twice with the jacks to install the inner and outer tires. 4 Brake clearance inspection holes on both wheels should be staggered. 5 The inner and outer wheel valves should be symmetrically arranged to facilitate inspection and adjustment of inner tube pressure.
Mingtai third generation Led Operating Lamp LED bulb do not engender infrared ray and ultraviolet radiation, it doesn`t have the temperature rise and tissue damage caused by halogen shadowless light, can accelerate the wound healing after surgery, and has no Radiation pollution
Variety of Surgical environment lighting mode: bright, normal, endoscopic lighting mode; Base axis has ambient light lighting mode (optional)
For more information about Operating Light, Operating Table, Hospital Bed and Medical Pendant please visit website.
Third Generation LED Shadowless Light
Third Generation LED Shadowless Light,Surgical Lamp,Shadowless Led Lamp,Overhead Surgical Lights
Shandong Mingtai Medical Equipment Group Co., Ltd , http://www.mingtaic.com